Skip to main content
cybermaggedon
Rank 1
Rank 1
Nov 20, 2026 11:43 AM UTC
Question

Have a smart electric meter but gas meter installation was aborted because of wireless range

A few years back, I had an electric smart meter installed.  The gas meter couldn’t be made smart because it’s too far / too many walls in the way from the electric meter.  Makes sense, they’re opposite sides of a house with solid walls.

The installers said I should give it a couple of years and try again because they were developing an extender for the HAN wireless range but it wasn’t available at the time.

I can live without a smart meter, but it bugs me that the gas meter is ancient, 30-40 years old maybe.

Anyone know if there are solutions for this case?

4 replies

Nukecad
Super User
Super User
Nov 20, 2026 12:49 PM UTC

The gas meter shouldn’t be that old, they are only certified for a set number of years and then have to be replaced by law.
It would be replaced with a smart meter, even if that smart meter cannot communicate because of distance/walls.

Could you post a clear photo of your current gas meter, with the printing on it visible so that we can see what it is and how old it is? (A photo of the electricity meter may be useful too).

As an aside, do you have a working in home display?

The solution that the installer was talking about is called Alt-HAN, it was on pause for a while due to a technical issue, but is now being installed again where necessary.
It basically a power-line extender for the Zigbee HAN signal..

In your case one unit plugged into an electrical socket near to the gas meter would send a HAN signal through your electrical wiring to another unit plugged in near to the electricity meter communications hub.
(And possibly a third unit might be fitted in the house if needed for a in home display).

For more information on how it works see: https://althanco.com/

If your gas meter really is that old then it’s worth contacting OVO (I assume you are an OVO customer) and requesting a gas meter replacement, noting that the current meter position is a long way from the electricity meter/comunications hub and so it will probably need Alt-HAN.

Out of beer error >>>> Recovering memory.
cybermaggedon
Rank 1
Rank 1
Nov 20, 2026 3:59 PM UTC

Thanks ​@Nukecad it looks like below.  Actaris G4. I found a document that explains the serial number, so it’s a 2010 manufacturer. Not as old as it looks. Has had a hard life 🤣

The meter is outside in a box. The other side of the wall has socket, so hopefully the Al-tHAN thing will work, I’ll take a look.

Yes, I have a working IHD - only shows the electric supply ATM.  Thanks for the response and link, much appreciated.
 

 

Chris_OVO
Community Manager
Community Manager
Nov 20, 2026 2:10 PM UTC

Hey ​@cybermaggedon,

 

Welcome to the community, 

 

As Nukecad mentioned, sharing a photo of your current setup would really help the community provide you with the best advice possible. Don’t forget to check your meter for a certification sticker, which shows when the certification expires. If you can’t find a sticker, we should be able to look it up through your account.

 

We’re looking forward to hearing back from you! In the meantime, it would be helpful to check out the link that Nukecad shared about Alt-HAN. There are also some great member stories about Alt-HAN installations that you can read here:

 

Renewable energy jokes never get old.
cybermaggedon
Rank 1
Rank 1
Nov 20, 2026 4:51 PM UTC

Thanks ​@Chris_OVO , I called customer services. There isn’t a record of certification expiry for this meter that could be tracked down on the line, so they’re organising a meter swap. We talked about the wireless range issue that’s result in specific installation instruction.