I have a shiny new Q4 e-tron with newly installed Zappi 2.1 integrated to Charge anytime. I have oberved an interesting behviour (repeatable). With the car connected and a ‘ready by’ set, if not charging immediately then the Q4 errors after a short while (infrastructure) and flashes red at the interface. However….and this is the intersting part. If one waits then at some point OVO kicks in an charging starts. So it seems to be a form of timer/ wait condition. Has any one else found this?
Audi Q4, ChargeAnytime and Zappi 2.1
+9- Super User
Hey
Which device did you link to Charge Anytime? You have a compatible Charger so that’s normally the best experience!
the Zappi…. I think ( but am not totally certain) that the issue may be more to do with how the Q4 handles wait times.
+9- Super User
Well, if it’s working I’d say don’t mess with it! :)
This behaviour is normal and suggests you might be hooked to the vehicle - check the OVO Charge app as it’ll tell you there. It’s normal for charging to start for a few minutes until OVO takes control and pauses the session. Smart Charging from there will be at CA rates.
Log in to the OVO Forum
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Contact us
Tips & advice
Resources
For business
OVO Energy Ltd, registered office 1 Rivergate Temple Quay Bristol, BS1 6ED, company no. 06890795 registered in England and Wales.
OVO (S) Gas Limited is registered in England and Wales (Company No. 02716495) at 1 Rivergate, Temple Quay, Bristol, BS1 6ED.
OVO (S) Gas Limited is part of OVO Group Ltd