Recently tried installing Tado v3+ wireless starter kit but left me with no power to boiler
worked out the cable asked to replace in instructions was power to boiler so put both Tado and boiler L and N cables in the relivant ports in boiler and had power
however when it came to test, boiler didn’t fire.
was previously using Salus RT520 thermostat, unsure whether this is wired or wireless to boiler
tried the Tado support with no luck, they didn’t seem to understand.
Hey
I’m sorry to hear that.
As Tado Support are the experts, we don’t have guides or experts on these types of installations here.
I did check out the Tado Support page which has access to their Support Chat, and a whole selection of guides including a section on ‘installations’. https://support.tado.com/en/
I’ve also included a link to the home page on the V3+, which may be helpful too; https://uk.shop.tado.com/products/wireless-smart-thermostat-starter-kit-v3.
I wonder if any of our other users with Smart Thermostats can offer some helpful advice?
It might be worth double checking on the install notes
I'm afraid my experience is with the wired smart thermostat. My Ecotec 831 Plus boiler works in either relay or eBus mode depending on the wiring. I've tried both. Following the wiring instructions correctly is, of course, essential to success.
Unfortunately I can't advise on alternate boiler and thermostat types.
No worries at all
Thanks both for your input
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
